IPAddr
coffee

De'Longi Coffee Machine Instructions

  1. On/Off Button
  2. 1 cup light
  3. 1 cup button
  4. 2 cups light
  5. 2 cups button
  6. Hot Water/Steam light
  7. Hot Water Selection Button
  8. Coffee Quantity Selector (Short, Normal or Long)
  9. Coffee Griding Quantity (Weak, Normal or Strong)
  10. Rinse and Descaling Button
  11. Use Pre-Ground Coffee Button
  12. Pre-Ground Coffee Light (Internal Grinder Disabled)
  13. Scale Alarm Light
  14. Generic Alarm Light
  15. Grounds Container Full Light
  16. Water Tank Missing or Empty

To make a mug of coffee

Put a mug under the spouts, set the volume of coffee knob to point straight up, set the coffee strength knob to about 10'o'clock, press the TWO CUP button (2 cups=1 mug) and wait.

To froth milk

Move the milk frothing nozzle to the right, put a cup under the nozzle, turn on the steam knob on the right of the machine and wait until the water stops running and turns to steam and then remove the cup and put the milk jug underneath, froth the milk and then turn off the steam when done.

To Make Hot Water

Move the milk frothing nozzle to the right, put a cup under the nozzle, press the Hot Water button, turn on the steam knob on the right of the machine, wait until the cup is full of hot water and then turn off the tap and press the hot water button again.

To De-Scale the machine

When the "Rinse and Descaling Button" light (13) is flashing it indicates a buildup of scale inside the coffee machine and the machine should be de-scaled as soon as possible. Note: It is still possible to continue to make coffee when this light is flashing.

  1. If you are using the DeLonghi descaling liquid then put the whole bottle (500ml) into the water tank and add another 500ml of clean water.
  2. For the Saeco de-Calcifying solution mix the whole bottle (250ml) with another litre of clean water.
  3. Put a clean container of at least 1.5L capacity under the milk frothing spout.
  4. Turn the machine on and wait until it has warmed up and the normal two lights stop flashing.
  5. Press and hold the descaling button (10) for 5 seconds and the light will then stop flashing and turn on while the other two lights will go off.
  6. Turn the hot water/steam nozzle on full and wait while the machine goes through it's paces of stop/start flushing of the pipes.
  7. After about 30 mins the water out light will come on so turn OFF the steam/hot water nozzle.
  8. Rinse the water container, refill it with clean water and replace it in the machine
  9. Empty the container that is full of the waste water and replace it back under the hot water/steam spout
  10. Turn the hot water/steam nozzle on full and wait while the machine goes through it's paces of stop/start flushing of the pipes.
  11. Wait until the water out light comes on again and turn OFF the steam/hot water nozzle.
  12. Refill the water container and the machine is now ready to make coffee again.